Note. Removal steps in this procedure may contain installation details.
Remove front bumper, see COVER BUMPER FRONT
Scheme 40
- Torque: M10 50 Nm
- Torque: M6 10 Nm
To install, reverse the removal procedure.
Note. Removal steps in this procedure may contain installation details.
Remove the bumper, see COVER BUMPER REAR
Scheme 41
Torque: M10
50 Nm
To install, reverse the removal procedure.
Follow the instructions regarding corrosion protection, see RUSTPROOFING
See information on welding, general, see WELDING, GENERAL
Remove rear fender, see FENDER
Follow the instructions regarding rear piece, see REAR SECTION
Scheme 42
Follow instructions for body sealing, see BODY SEAL, SEALING DIAGRAM
Follow the instructions regarding corrosion protection, see RUSTPROOFING
Install rear fender, see FENDER
Note. Removal steps in this procedure may contain installation details.
Remove the plenum cover, see PLENUM CHAMBER (2007-2010) or PLENUM CHAMBER (2011, 2012)
Scheme 43
Torque: M6
10 Nm
Scheme 44
To install, reverse the removal procedure.
See information on welding, general, see WELDING, GENERAL
Remove the rear section, exposing, see REAR SECTION, EXPOSING
Follow the instructions regarding rear side members, see SIDE MEMBERS REAR
Follow the instructions regarding rear piece, see REAR SECTION
Scheme 45
Scheme 46
Scheme 47
Scheme 48
On both sides.
See information about body sealant, sealing diagram, see BODY SEAL, SEALING DIAGRAM
See information about corrosion protection, see RUSTPROOFING
Install the rear section, exposing, see REAR SECTION, EXPOSING