Installation
Install
- the steering wheel according to Steering wheel, replacing
- the battery lead. See Battery, disconnecting.
Note. For tightening torques, see: Tightening torque.
| CAUTION | The IC (inflatable curtain) module must not be reinstalled if it has been dropped onto the ground or similar. |
- Lift in and open the packaging according to the instructions
- Install clip C
- Install the ground terminal 1 (screw in until the thread engages only).
Remove the packaging by pulling it straight downwards.
Note. Ensure that no bits of paper remain.
- Install screws 2 and 8.
(4 and 5 are installed when installing the grab handles)
Hook on the inflatable curtain module. Install screw 3.
Note. It is very important that the hook is correctly installed.
Install
- clip G.
(6 and 7 are installed when installing the grab handles)
Tighten screws 1-7. Tighten to 10 Nm.
Install
- The connector
- The headlining. See Headlining, replacing.
| CAUTION | When replacing the inflatable curtain module, part of the decal on the curtain must be torn off and stuck on the decal in the door opening. |