REMOVAL & INSTALLATION
| WARNING | To avoid injury from accidental air bag deployment, read and carefully follow all SERVICE PRECAUTIONS and DISABLING & ACTIVATING AIR BAG SYSTEM procedures in the AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/SAFETY EQUIPMENT section. |
- Disconnect negative battery cable. Remove trim panel below glove box. Open glove box door. Remove glove box screws and glove box.
- Detach wiring harness and bracket from blower motor housing. Disconnect blower motor. Remove blower motor screws and blower motor. To install, reverse removal procedure.
For removal and installation procedures, see SANDEN SD7H15 A/C COMPRESSOR - REPLACEMENT OF CLUTCH or REPLACING A/C COMPRESSOR PULLEY & CLUTCH .
- Disconnect negative battery cable. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove receiver-drier from engine compartment firewall. Remove cover plate and foam rubber seal from firewall.
- Remove trim panel below glove box. Open glove box door. Remove glove box screws and glove box. Remove evaporator housing end cover. (Scheme 2) Carefully remove evaporator core. To install, reverse removal procedure.
Note. Additional removal and installation procedures are not available.
