Home ReviewsRefund
Home/Volkswagen/Golf/Volkswagen Golf Mk6 (2008-2012)/Repair manual/Controls, Housing - Automatic Transmission 02E/SELECTOR LEVER CABLE, ADJUSTING
Contents Wiring diagrams Section: Controls, Housing - Automatic Transmission 02E All sections

SELECTOR LEVER CABLE, ADJUSTING Volkswagen Golf Mk6

Controls, Housing - Automatic Transmission 02E 2 illustrations ~234 words

SELECTOR LEVER CABLE, ADJUSTING

Special tools and workshop equipment required

  1. Torque Wrench (5-50 Nm) -V.A.G 1331

The selector lever cable must always be adjusted if

  1. The selector lever cable was removed from the transmission.
  2. The engine and/or transmission were removed and installed.
  3. Parts of engine/transmission mount were removed and installed.
  4. The cable itself or the selector mechanism was removed and installed.
  5. Engine/transmission positions changed, for example, were installed free of tension.

Adjusting

Move the selector lever into the "P" position.

Move the lever on the transmission into the "P" position.

Scheme 38

Scheme 38
Scheme 38

The lever on the transmission must be pushed all the way to the rear.

Pull the lever forward.

Push the lever to the rear

"P" is in the second detent.

Note. Make sure the transmission is actually in the "P" position (parking lock is engaged) if raising the vehicle. It must not be possible to turn the front wheels. The transmission is also in the "P" position if the vehicle does not move with wheels spinning freely.

Install the cable with a loose adjustment bolt -arrow- and the new lock washers -A and B-.

Scheme 39

Scheme 39
Scheme 39

Lightly tap the button in the handle forward and backward and make sure to keep the handle in the position "P" position.

This locates the cable core in its optimal position.

Tighten the adjustment bolt to 13 Nm.

This ends the adjustment.