Basic Setting (function 04) Volkswagen Golf Mk4

Basic Setting (function 04)

Note. The following applies to models through m.y. 2001 ONLY OBD from m.y. 2002 must be performed using VAS 5051. Refer to General Information .

Note. If the display flashes after switching ignition on, even though no Diagnostic Trouble Codes (DTC) are in DTC memory, perform function 07 Code Control Module followed by function 04 Basic Setting.

Basic Setting, initiating

1. Connect VAG 1551 Scan Tool (ST), enter address word 08 "AC./Heating electronics" and press --> until "Select function XX" appears in display. Refer to «Climatronic On Board Diagnostic (OBD) through m.y. 2001, initiating checking control module versions»(ref-255032-S41233280692007052300000) .
2. Switch printer on by pressing PRINT button (warning lamp in button lights up).
3. Check DTC memory. Refer to «Diagnostic Trouble Code (DTC) memory, checking (function 02)»(ref-255032-S33890746362007052300000) and correct all malfunctions shown.
4. Erase DTC memory. Refer to «Diagnostic Trouble Code (DTC) memory, erasing (function 05)»(ref-255032-S01370935802007052300000)
5. Check code. Refer to «Climatronic Control Module J255 , coding (function 07)»(ref-255032-S14976239362007052300000) and correct if necessary.

Indicated on display (function selection)

1. Press buttons - 0 - and - 4 - to select function 04 Basic Setting.

Indicated on display

1. Press - Q - button to confirm entry.

Indicated on display

1. Enter display group number 000

Indicated on display

1. Press - Q - button to confirm entry.

Note. The Climatronic control module J255 stores all flap motor position sensor (potentiometer) values when moving to their final positions and therefore takes on the Basic Setting of all flap motors.

Indicated on display

Note. The movement of the four flap motors can be followed on the display. The changes in the feedback values do not give an indication of a malfunctioning motor.

Indicated on display

The Basic Setting is completed when the display reads "0 DTCs recognized" in the DTC memory.

1. Press --> button.

Indicated on display (function selection)

1. Press buttons - 0 - and - 2 - to select function 02 Check DTC memory.

Indicated on display

1. Press - Q - button to confirm entry.

The number of stored DTCs or "No DTC recognized" appears in the display.

1. Press --> button. The stored DTCs are displayed one after the other and printed out by pressing the Print button.
2. When the last DTC has been displayed and printed out, repair DTCs using DTC table. Refer to «Diagnostic Trouble Code (DTC) table»(ref-255032-S03686046032007052300000) .
3. Press --> button.

Indicated in display (function selection, e.g. 02 - Check DTC memory)