Engine Ignition System: Removal & Installation Toyota Sienna II рестайлинг

INSTALLATION

1. INSTALL SPARK PLUG Install the 6 spark plugs. Torque: 18 N*m (183 kgf*cm, 13 ft.*lbf)
2. INSTALL IGNITION COIL ASSEMBLY Install the 6 ignition coils with the 6 bolts. Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) Connect the 6 ignition coil connectors.
3. INSTALL NO. 1 SURGE TANK STAY NOTE: DO NOT apply oil to the bolt listed below: BOLT TIGHTENING SPECIFICATION Tightening Parts No. 1 surge tank stay and cylinder head cover Install the No. 1 surge tank stay with the bolt. Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) Install the 2 bolts, 2 clamps, and nut. Torque: 8.3 N*m (84 kgf*cm, 73 in.*lbf)
4. INSTALL INTAKE AIR SURGE TANK ASSEMBLY (See «INSTALLATION»(ref-282130-S11295629962008032900000) )
5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See «INSTALLATION»(ref-282130-S11295629962008032900000) )
6. ADD ENGINE COOLANT (See «REPLACEMENT»(ref-282121-S21837721452008032900000) )
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSPECT FOR ENGINE COOLANT LEAK (See «ON-VEHICLE INSPECTION»(ref-282121-S29540350622008032900000) )
9. INSTALL V-BANK COVER SUB-ASSEMBLY (See «INSTALLATION»(ref-282118-S40760919202008032900000) )
10. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT (See «INSTALLATION»(ref-282130-S11295629962008032900000) )
11. INSTALL NO. 1 COWL TOP TO COWL BRACE INNER (See «INSTALLATION»(ref-282130-S11295629962008032900000) )
12. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (See «INSTALLATION»(ref-282135-S11664405272008032900000) )
13. INSTALL FRONT WIPER ARM LH (See «INSTALLATION»(ref-282135-S11664405272008032900000) )
14. INSTALL FRONT WIPER ARM RH (See «INSTALLATION»(ref-282135-S11664405272008032900000) )