GENERATOR SPECIFICATIONS
| Application | Specification | |||
|---|---|---|---|---|
| Brush Length | ||||
| Standard | .374-.453 Inch (9.5-11.5 mm) | |||
| Limit (Minimum) | More Than .059 Inch (1.5 mm) | |||
| Rotor | ||||
| Resistance (1) | ||||
| 90-Amp | 2.1-2.5 Ohms | |||
| 100-Amp | 2.3-2.7 Ohms | |||
| Slip Ring Diameter | ||||
| Standard | .551-.567 Inch (14.0-14.4 mm) | |||
| Minimum | ||||
| 90-Amp | .504 Inch (12.8 mm) | |||
| 100-Amp | .551 Inch (14.0 mm) | |||
| Generator Regulated Output | ||||
| Amperage | ||||
| Without Load | 10 Or Less Amps | |||
| With Load | 30 Or More Amps | |||
| Voltage | 13.2-14.8 Volts | |||
| (1) Measured @ 68°F (20°C). | ||||
| (1) | Measured @ 68°F (20°C). |
GENERATOR SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Generator Mounting Bolt | ||
| 8-mm | 15 (21) | |
| 10-mm | 38 (52) | |
| Pulley Nut | 81 (111) | |
| INCH Lbs. (N.m) | ||
| Battery Wire Terminal Nut | 36 (4.1) | |
| Bearing Retainer Bolt | ||
| 90 amp | 27 (3.0) | |
| 100 amp | 20 (2.3) | |
| Brush Holder Screw | 16 (1.8) | |
| Drive End Frame Bolt/Nut | ||
| With Cord Clip | 40 (4.5) | |
| Without Cord Clip | 51 (5.8) | |
| Generator Holder With Rectifier | 26 (2.9) | |
| Generator Rear End Cover | ||
| Screw | 35 (3.9) | |
| Nut | 41 (4.6) | |
| Regulator Assembly | 18 (2.0) | |
TORQUE SPECIFICATIONS