| WARNING | Read service precautions before proceeding with service procedure. See SERVICE PRECAUTIONS . |
| CAUTION | If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. |
Note. If DTC P0441, P0446, P0450 or P0451 is output after DTC P0440, perform appropriate test for these DTCs first before performing test for DTC P0440.
Circuit Description
Vapor pressure sensor, canister closed valve Vacuum Switching Valve (VSV) and purge flow switching valve Vacuum Switching Valve (VSV) are used to detect abnormalities in the EVAP system. DTC is set if vapor pressure sensor malfunctions. Possible causes are
- Vapor pressure sensor circuit is open or shorted.
- Defective vapor pressure sensor.
- Defective ECM.
Diagnostic Aids
Using Toyota hand-held tester or scan tool, read FREEZE FRAME data. Freeze frame data records engine conditions when malfunction is detected. When ENGINE RUN TIME in freeze frame data is less than 200 seconds, check EVAP VSV, charcoal canister and vapor pressure sensor.