Home ReviewsRefund
Home/Toyota/Prius PHV/Toyota Prius PHV pre-III (2010-2011)/Repair manual/Engine Control (sfi) System (diagnostic Codes (p0010-p0300)) (phv)/COMPONENT OPERATING RANGE
Contents Section: Engine Control (sfi) System (diagnostic Codes (p0010-p0300)) (phv) All sections

COMPONENT OPERATING RANGE Toyota Prius PHV pre-III

Engine Control (sfi) System (diagnostic Codes (p0010-p0300)) (phv) 2 illustrations ~304 words

COMPONENT OPERATING RANGE

VVT oil control valve conditionOperation record

Scheme 605

Scheme 605: CONFIRMATION DRIVING PATTERN
Scheme 605: CONFIRMATION DRIVING PATTERN
  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure). Refer to «DTC CHECK / CLEAR»(/toyota/prius-phv/pre-iii-2010-2011/remont/testing-diagnostics/#engine-control-sfi-system-diagnostics-introduction-phv__dtc-checkclear) .
  4. Turn the power switch off and wait for 30 seconds.
  5. Turn the power switch on (IG) and turn the Techstream on.
  6. Wait 5 seconds [A].
  7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
  8. Read the DTC [B].
  9. If a DTC is output, the system is malfunctioning. HINT: If a DTC is not output, perform the following procedure.
  10. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
  11. Input the DTC: P0010.
  12. Check the DTC judgment result. Techstream Display Description NORMAL DTC judgment completed System normal ABNORMAL DTC judgment completed System abnormal INCOMPLETE DTC judgment not completed Perform driving pattern after confirming DTC enabling conditions UNKNOWN Unable to perform DTC judgment Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit HINT: If the judgment result shows ABNORMAL, the system has a malfunction. If the judgment result shows NORMAL, the system is normal. If the judgment result shows INCOMPLETE or UNKNOWN, perform step [A] again.
  13. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
  14. Check the judgment result. HINT: If the judgment result shows ABNORMAL, the system has a malfunction. If the judgment result shows NORMAL, the system is normal.
  15. If the test result is INCOMPLETE or UNKNOWN and no DTC is output, perform a universal trip and check for permanent DTCs. Refer to «DTC CHECK / CLEAR»(/toyota/prius-phv/pre-iii-2010-2011/remont/testing-diagnostics/#engine-control-sfi-system-diagnostics-introduction-phv__dtc-checkclear) . HINT: If a permanent DTC is output, the system is malfunctioning. If no permanent DTC is output, the system is normal.

Scheme 606

Scheme 606: WIRING DIAGRAM
Scheme 606: WIRING DIAGRAM