TORQUE SPECIFICATION
| Part tightened | N.m | Kgf.cm | Ft.lbf | |
|---|---|---|---|---|
| SEQUENTIAL MANUAL TRANSMISSION UNIT | ||||
| Filler and drain plugs | 39 | 400 | 29 | |
| Engine hood x Body | 20 | 204 | 15 | |
| Suspension upper brace x Body | Bolt | 74 | 755 | 55 |
| Nut | 80 | 816 | 59 | |
| Battery bracket x Body | 24 | 245 | 18 | |
| Throttle body bracket x Transmission body | 49 | 500 | 36 | |
| Throttle body bracket x Throttle body | 49 | 500 | 36 | |
| Throttle body x Engine | 30 | 306 | 22 | |
| Transmission x Engine (From transaxle side) | 64 | 650 | 47 | |
| No. 1 engine hangers set bell | 38 | 387 | 28 | |
| Left engine mounting insulator | Through bolt and nut | 87 | 887 | 64 |
| Bolt | 52 | 530 | 38 | |
| Front engine mounting bracket | Through bolt and nut | 93 | 949 | 69 |
| Bolt | 78 | 796 | 56 | |
| Starter x Starter cable | 9.8 | 100 | 87 in..lbf | |
| Transmission x Starter | 37 | 378 | 28 | |
| Transmission x Ground cable | 19 | 195 | 14 | |
| Rear engine mounting insulator | Through bolt and nut | 93 | 949 | 69 |
| Bolt | 89 | 908 | 66 | |
| Rear engine mounting bracket | 78 | 796 | 58 | |
| Transmission x Engine (From engine side) | Bolt A | 47 | 480 | 35 |
| Bolt B | 23 | 230 | 17 | |
| Axle carrier x Shock absorber | 173 | 1.765 | 128 | |
| Axle hub x Drive shaft | 216 | 2,200 | 159 | |
| Strut rod x Axe carrier | 78 | 796 | 58 | |
| No. 1 lower suspension arm x Axle earner | 103 | 1,051 | 76 | |
| No. 2 lower suspension arm x Axle carrier | 49 | 500 | 36 | |
| Drive shaft eerier bearing case lock bolt | 64 | 650 | 47 | |
| Lever lock pin set nut | 12 | 122 | 9 | |
| Engine wire bracket x Transmission body | 8 | 82 | 71 in..lbf | |
| Flexible hose bracket x Transmission body | 19.6 | 200 | 14 | |
| Transmission case x Transmission case cover | 18 | 185 | 13 | |
| SEQUENTIAL MANUAL TRANSMISSION ASSEMBLY | ||||
| Lock ball assembly (Shift and select lever shaft side) | 29 | 300 | 22 | |
| Control shaft cover x Transmission case | 20 | 200 | 14 | |
| Gear shift fork set bolt | 16 | 160 | 12 | |
| Rear bearing retainer x Transmission case | 27 | 280 | 20 | |
| Reverse idler gear shaft lock bolt | 29 | 300 | 22 | |
| Straight screw plug | Plug A | 13 | 130 | 9 |
| Plug B | 29 | 300 | 22 | |
| Back-up light switch | 40 | 410 | 30 | |
| Neutral start switch | 29 | 296 | 21 | |
| Transmission case x Transaxle case | 29 | 300 | 22 | |
| Oil receiver pipe set bolt | 17 | 175 | 13 | |
| Reverse shift arm bracket x Transaxle case | 17 | 175 | 13 | |
| No. 1 gear shift head sot bolt | 16 | 160 | 12 | |
| Output shaft front bearing lock plate set bolt | 11 | 115 | 8 | |
| Transaxle case receiver x Transaxle case | 11 | 115 | 8 | |
| Straight screw plug (Reverse restrict pin) | 22 | 224 | 16 | |
| DIFFERENTIAL CASE | ||||
| Differential case x Ring gear | W/o LSD | 77 | 790 | 57 |
| W/ LSD | 101 | 1,030 | 74 | |
| INPUT SENSOR | ||||
| Input sensor x Transmission body | 8 | 82 | 71 in..lbf | |
| GEAR SHIFT ACTUATOR (GSA) | ||||
| Stroke sensor (select, clutch and shift) x GSA | 2.2 | 22 | 19 in..lbf | |
| GSA assembly x Transmission body | 42 | 428 | 31 | |
| Fuel tank inlet pipe x Transmission body | Bolt | 27 | 275 | 20 |
| Fuel tank inlet pipe x Body | Nut | 8.5 | 87 | 75 in..lbf |
| Shift and select lever shaft assembly x GSA assembly | 25 | 255 | 18 | |
| GSA connector bracket x GSA assembly | 8 | 82 | 71 in..lbf | |
| HYDRAULIC POWER UNIT (HPU) | ||||
| HPU x HPU bracket | 22 | 224 | 16 | |
| HPU bracket x Rear suspension member | 26 | 265 | 19 | |
| SHIFT LEVER | ||||
| Driver and passenger seat | 37 | 375 | 27 | |
| Shift lever assembly set bolt | 12 | 120 | 9 | |
Torque Specification