TORQUE SPECIFICATION
| Part tightened | N.m | Kgf.cm | Ft.lbf |
|---|---|---|---|
| TILT STEERING COLUMN | |||
| Adjusting nut | See Service Information | ||
| No. 2 tilt lever lock bolt | 5.4 | 55 | 48 in..lbf |
| Tilt steering support x Column tube | 15 | 155 | 11 |
| No. 2 intermediate shaft assembly x Main shaft assembly | 35 | 360 | 26 |
| Column assembly set bolt and nut | 21 | 210 | 15 |
| No. 2 intermediate shaft assembly x Control valve assembly | 35 | 360 | 26 |
| Steering wheel set nut | 50 | 500 | 35 |
| Steering wheel pad set screw (Torx screw) | 8.8 | 90 | 78 in..lbf |
| POWER STEERING VANE PUMP | |||
| Rear housing set bolt | 8.5 | 90 | 7.5 in..lbf |
| Reservoir clamp bolt | 7.0 | 70 | 61 in..lbf |
| PS vane pump set bolt and nut | 19 | 190 | 14 |
| Pressure feed tube x PS vane pump assembly | 39.5 (43) | 400 (440) | 29 (32) |
| POWER STEERING GEAR | |||
| Control valve housing x Rack housing | 21 | 210 | 15 |
| Control valve self-locking nut | 24.5 | 250 | 18 |
| Rack guide spring cap lock nut x Rack housing | 28 (39) | 290 (400) | 21 (29) |
| Rack end x Steering rack | 62 (83) | 630 (850) | 46 (61) |
| Tie rod end lock nut | 47 | 480 | 35 |
| Turn pressure tube x Rack housing | 10 (13) | 100 (130) | 7 (9) |
| Pressure feed tube assembly x PS gear assembly | 22.5 (24.5) | 230 (250) | 17 (18) |
| Pressure feed tube assembly x PS vane pump assembly | 39.5 (43) | 400 (440) | 29 (32) |
| PS gear assembly x Steering gear support member | 57 | 580 | 42 |
| (): For use without SST | |||
Torque Specification