GENERATOR SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .374-.453 Inch (9.5-11.5 mm) | ||
| Limit (Minimum) | More Than .059 Inch (1.5 mm) | ||
| Rotor | |||
| Resistance (1) | 2.1-2.5 ohms | ||
| Slip Ring Diameter | |||
| Standard | .559-.567 Inch (14.2-14.4 mm) | ||
| Minimum | .504 Inch (12.8 mm) | ||
| Generator Regulated Output | |||
| Amperage | |||
| Without Load | 10 Or Less Amps | ||
| With Load | 30 Or More Amps | ||
| Voltage | 12.9-14.9 Volts | ||
| (1) Measured @ 68°F (20°C). | |||
| (1) | Measured @ 68°F (20°C). |
GENERATOR SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Generator Mounting Bolt | ||
| 12-mm Bolt | 18 (25) | |
| 14-mm Bolt | 39 (54) | |
| Generator Pulley Nut | 81 (111) | |
| Right Side Engine Mounting Insulator | 38 (52) | |
| INCH Lbs. (N.m) | ||
| Battery Wire Terminal Nut | 36 (4.1) | |
| Bearing Retainer Bolt | 27 (3.0) | |
| Brush Holder Screw | 18 (2.0) | |
| Rectifier Holder Screw | 26 (2.9) | |
| Rectifier End Frame | ||
| Nut | 40 (4.5) | |
| Nut With Cord Clip | 48 (5.4) | |
| Rear End Cover | ||
| Bolt | 35 (3.9) | |
| Nut | 39 (4.4) | |
| Regulator Screws | 18 (2.0) | |
TORQUE SPECIFICATIONS