GENERATOR SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .374-.453 In. (9.5-11.5 mm) | ||
| Limit (Minimum) | More Than .059 In. (1.5 mm) | ||
| Rotor | |||
| Resistance (1) | |||
| Automatic Transaxle | 2.1-2.5 Ohms | ||
| Manual Transaxle | 2.7-3.1 Ohms | ||
| Slip Ring Diameter | |||
| Standard | .559-.567 In. (14.2-14.4 mm) | ||
| Minimum | .504 In. (12.8 mm) | ||
| Generator Regulated Output | |||
| Amperage | |||
| Without Load | 10 Or Less Amps | ||
| With Load | 30 Or More Amps | ||
| Voltage | 13.2-14.8 Volts | ||
| (1) Measured @ 68°F (20°C). | |||
| (1) | Measured @ 68°F (20°C). |
GENERATOR SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Generator Mounting Bolt | |||
| 14-mm Bolt | 18 (25) | ||
| 17-mm Bolt | |||
| With 1ZZ-GE Engine | 40 (54) | ||
| With 2ZZ-GE Engine | 43 (58) | ||
| Generator Pulley Nut | 81 (111) | ||
| INCH Lbs. (N.m) | |||
| Battery Wire Terminal Nut | 36 (4.1) | ||
| Bearing Retainer Bolt | 27 (3.0) | ||
| Brush Holder Bolt | 18 (2.0) | ||
| Generator Holder With Rectifier | 26 (2.9) | ||
| Generator Rear End Cover | |||
| Bolt | 35 (3.9) | ||
| Nut | 39 (4.4) | ||
| Regulator Assembly | 18 (2.0) | ||
TORQUE SPECIFICATIONS