Home ReviewsRefund
Home/Toyota/Celica/Toyota Celica T230 (1999-2002)/Repair manual/Engine Controls - System & Component Testing - 4-CYLINDER/IG2 RELAY
Contents Wiring diagrams Section: Engine Controls - System & Component Testing - 4-CYLINDER All sections

IG2 RELAY Toyota Celica T230

Engine Controls - System & Component Testing - 4-CYLINDER 1 illustration ~182 words

IG2 RELAY

Note. IG2 relay may also be referred to as ignition relay.

IG2 relay is located in fuse/relay box at driver-side front corner of engine compartment, just in front of strut tower, near battery. Testing information is not available from manufacturer. Consult wiring diagram for IG2 relay testing. See WIRING DIAGRAMS article.

Scheme 160

Scheme 160: RAV4
Scheme 160: RAV4
  1. Remove IG2 relay from relay box located at driver-side front corner of engine compartment, just in front of strut tower. (Scheme 160)
  2. To test IG2 relay continuity, using ohmmeter, check for continuity and no continuity between specified terminals on IG2 relay. see scheme 103
  3. To test IG2 relay operation, apply battery voltage and ground to IG2 relay. Using ohmmeter, check for continuity between specified terminals on IG2 relay. see scheme 103 Replace IG2 relay if defective.

INJ relay is located in fuse/relay box at driver-side front corner of engine compartment, just in front of battery. Testing information is not available from manufacturer. Consult wiring diagram for INJ relay testing. See WIRING DIAGRAMS article.

See CIRCUIT OPENING RELAY under RELAYS.

See EFI MAIN RELAY under RELAYS.