Starting System: Removal & Installation Toyota Celica T200 рестайлинг

Removal & Installation (1.8L)

1. Disconnect negative battery cable. Disconnect intake air temperature sensor and accelerator cable from clamp on air cleaner hose. Disconnect cruise control actuator cable from clamp on air cleaner hose (if equipped). Remove vacuum hose (from port "P" of throttle body) from air cleaner hose.
2. Disconnect 4 clamps, and disconnect air cleaner cap from air cleaner case. Loosen hose clamp, and disconnect air cleaner hose from throttle body. Remove air cleaner cap and air cleaner hose assembly.
3. Remove bolt, and disconnect wire clamp from transaxle. Disconnect starter connector. Remove nut, and disconnect starter cable. Remove 2 bolts and starter. To install, reverse removal procedure. Tighten starter mounting bolts to 29 ft. lbs. (39 N.m).

Removal & Installation (2.2L)

1. Disconnect negative battery cable. Disconnect air intake temperature sensor connector from air cleaner assembly. On California models, remove spark plug wire from air cleaner hose. If equipped with cruise control, remove cruise control actuator cable from clamps.
2. On California models, remove air hose for idle-up from air cleaner hose. On all models, disconnect 4 clamps, and disconnect air cleaner cap from air cleaner case. Loosen hose clamp, and disconnect air cleaner hose from throttle body.
3. Remove air cleaner cap and air cleaner hose assembly. Remove air filter. Disconnect 2 engine wires from clamps on air cleaner case. Remove 3 bolts and air cleaner case. Remove battery. If equipped with cruise control, disconnect cruise control actuator connector.
4. Remove 3 bolts, and disconnect actuator from body bracket. On all models, disconnect starter connector. Remove nut, and disconnect starter cable. Remove 2 bolts, and disconnect oxygen sensor connector and engine wire brackets from starter. Remove starter. To install, reverse removal procedure. Tighten starter mounting bolts to 29 ft. lbs. (39 N.m).