Home ReviewsRefund
Home/Toyota/Camry/Toyota Camry XV20 (1994-2002)/Repair manual/Engine Controls - System/component Tests - 4-CYL/RAV4
Contents Wiring diagrams Section: Engine Controls - System/component Tests - 4-CYL All sections

RAV4 Toyota Camry XV20

Engine Controls - System/component Tests - 4-CYL ~208 words

RAV4

  1. Note location of E2 terminal (Brown wire), VC terminal (Yellow wire) and VTA terminal (Blue/Red wire) on TP sensor. Ensure ignition is off. Disconnect electrical connector from Throttle Position (TP) sensor on throttle body. Apply vacuum to throttle opener.
  2. Using ohmmeter, check resistance between specified terminals in relation to throttle position. See «TP SENSOR RESISTANCE SPECIFICATIONS (RAV4 - 2.0L)»(ref-95581-S17253528612004022300000) table. Replace components as necessary if resistance is not within specification.
  1. Ensure ignition is off. Disconnect electrical connector from TP sensor on throttle body. Note terminal identification on TP sensor. see scheme 42 Apply vacuum to throttle opener.
  2. Using ohmmeter, check resistance between specified terminals in relation to throttle position. See «TP SENSOR RESISTANCE SPECIFICATIONS (TACOMA - 2.4L & 2.7L)»(ref-95581-S21937061152004022300000) or «TP SENSOR RESISTANCE SPECIFICATIONS (T100 & 4RUNNER - 2.7L)»(ref-95581-S07704705032004022300000) table. Replace components as necessary if resistance is not within specification.
  1. Ensure ignition is off. Disconnect electrical connector from TP sensor on throttle body. Note terminal identification. see scheme 43 On A/T models, disconnect throttle cable from linkage before checking TP sensor.
  2. On all models, use ohmmeter to check resistance between specified terminals in relation to throttle position. See «TP SENSOR RESISTANCE SPECIFICATIONS (TERCEL - 1.5L)»(ref-95581-S42582787322004022300000) table. Replace components as necessary if resistance is not within specification.