Home ReviewsRefund
Home/Toyota/4Runner/Toyota 4Runner III (1995-2003)/Repair manual/Differentials & Drive Axles/Automatic Disconnecting Differential: Removal & Installation
Contents Wiring diagrams Section: Differentials & Drive Axles All sections

Automatic Disconnecting Differential: Removal & Installation Toyota 4Runner III

Differentials & Drive Axles ~175 words

Removal & Installation

ADD relay is located behind instrument panel. Use illustrations for locating ADD relay. (Схема №1)or (Схема №2).

ADD solenoids are located in engine compartment. Use illustrations for locating ADD solenoids. (Схема №1)or (Схема №2).

  1. Disconnect electrical connector from ADD indicator switch located on front differential. Unscrew ADD indicator switch from differential. Remove gasket from ADD indicator switch.
  2. To install, reverse removal procedure using NEW gasket. Tighten ADD indicator switch to specification. See «TORQUE SPECIFICATIONS»(ref-8759-S21944881472000092100000) . Reinstall electrical connector.
  1. Disconnect electrical connector from 4WD switch, located on transfer case. (Схема №1) Unscrew 4WD switch from transfer case. Remove gasket from 4WD switch.
  2. To install, reverse removal procedure using NEW gasket. Tighten 4WD switch to specification. See «TORQUE SPECIFICATIONS»(ref-8759-S21944881472000092100000). Reinstall electrical connector.
  1. Disconnect electrical connector from transfer indicator switch, located on transfer case. (Схема №2) Unscrew transfer indicator switch from transfer case. Remove gasket from transfer indicator switch.
  2. To install, reverse removal procedure using NEW gasket. Tighten transfer indicator switch to specification. See «TORQUE SPECIFICATIONS»(ref-8759-S21944881472000092100000). Reinstall electrical connector.

More articles — Automatic Disconnecting Differential