Home ReviewsRefund
Home/Suzuki/X-90/Suzuki X-90 I (1995-2000)/Repair manual/Removal & Installation/Engine Controls - Remove/install/overhaul: Other
Contents Wiring diagrams Section: Removal & Installation All sections

Engine Controls - Remove/install/overhaul: Other Suzuki X-90 I

Removal & Installation ~104 words

FUEL SYSTEM

WARNINGALWAYS relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components.

FUEL SYSTEM PRESSURE RELEASE

CAUTIONDO NOT perform this procedure when engine is hot. Doing so may have an adverse effect on catalytic convertor.
  1. Place transmission in Neutral (M/T) or Park (A/T). Set parking brake and block drive wheels. Disconnect fuel pump relay. See the «FUEL PUMP RELAY LOCATION»(ref-26309-S17469435122001010500000) table.
  2. Remove fuel filler cap to release fuel vapor pressure in fuel tank. Reinstall fuel filler cap. Start engine and run until engine dies. After engine dies, crank engine 2-3 times for about 3 seconds to dissipate fuel pressure in lines. To restore normal operation, reinstall fuel pump relay.
ApplicationLocation
X-90Passenger Compartment, Attached To Heater Case

FUEL PUMP RELAY LOCATION

THROTTLE POSITION (TP) SENSOR

Note. For adjustment and testing procedures, see the SYSTEM/COMPONENT TESTS article.

More articles — Engine Controls - Remove/install/overhaul