Security & Locks: Overview Suzuki Vitara I

Key Usage and Identification

Key is used for ignition and door lock cylinder. Keys are cut on both edges to make them reversible.

Key identification is obtained from five character key code stamped on key code tag. Using this key code, key code cutting combination can be determined from a code list (available to owners of key cutting equipment from suppliers).

If key codes are not available from records or tags, key code can be obtained from the right hand door lock cylinder (if lock has not been replaced). Lock cylinders supplied by the factory as service parts are unmarked.

If original key is available, key code cutting combination can be determined by laying key.

Power Door Lock Operation

1. With the driver side door key turned LOCK, check all power doors are locked.
2. With the driver side door key turned UNLOCK, check only the driver side power door is unlocked. Turn the driver side door key to UNLOCK again within 5 seconds, check all power doors are unlocked. If check result of Step 1 and Step 2 is satisfactory, this operation is OK.

Keyless Entry Operation

1. With ignition switch OFF and all doors closed, push LOCK button on transmitter. Check all power doors are locked.
2. Push UNLOCK button on transmitter. Check only driver side power door is unlocked.
3. Push UNLOCK button on transmitter again within 5 seconds. Check all power doors are unlocked. But if any door is not opened within 30 seconds after power door(s) unlocked, all power doors are locked again automatically. If check result of Step 1 to Step 3 is satisfactory, this operation is OK.

Hazard Warning Lights Operation

1. Check that hazard warning lights flash one time when power doors are locked by pushing LOCK button on transmitter.
2. Check that hazard warning lights flash two times when power door(s) is (are) unlocked by pushing UNLOCK button on transmitter. If check result of Step 1 and Step 2 is satisfactory, this operation is OK.

Interior Light Operation

1. With the ignition switch OFF and all doors closed, push UNLOCK button on transmitter. Check that interior light stays on for 20 seconds.
2. Push UNLOCK button again, turn ignition switch ON within 20 seconds. Check that interior light goes out. If check result of Step 1 and Step 2 is satisfactory, this operation is OK.

Scheme 1

1. Disconnect negative (-) cable at battery.
2. Disconnect coupler of power door lock and keyless entry controller.
3. Use a 12 V battery to connect its (+) terminal to terminal E02-1, and its (-) terminal to terminal E02-2 and E02-3. Check all power doors are locked. If check result is satisfactory, this circuit is OK.