APPLICATION ITEM
SDT performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
|---|---|
| Utility | Changes the setting for each system function. |
| DTC check | Displays the diagnosis results judged by BCM. Refer to [ DTC INDEX: BCM ] |
| Bus check | Monitors the reception status of CAN communication viewed from BCM. |
| Data list | The BCM input/output signals are displayed. |
| Active test | The signals used to activate each device are forcibly supplied from BCM. |
| C/U Part Number | The BCM part number is displayed. |
| Configuration | Enables to read and save the vehicle specification. Enables to write the vehicle specification when replacing BCM. |
DIAGNOSIS MODE CHART
SYSTEM APPLICATION
BCM can perform the following functions for each system.
Note. It can perform the diagnosis modes except the following for all sub system selection items.
| System | Sub system selection item | Diagnosis mode | ||
|---|---|---|---|---|
| Utility | Data list | Active test | ||
| BCM | BCM | X | ||
| Door lock | DOOR LOCK | X | X | X |
| Warning chime | BUZZER | X | X | |
| Interior room lamp timer | INT LAMP | X | X | X |
| Remote keyless entry system | MULTI REMOTE ENT | X | X | X |
| Exterior lamp | HEAD LAMP | X | X | X |
| Wiper and washer | WIPER | X | X | X |
| Turn signal and hazard warning lamps | FLASHER | X | X | |
| Air conditioner | AIR CONDITONER | X | ||
| Combination switch | COMB SW | X | ||
| Immobilizer | IMMU | X | X | |
| Interior room lamp battery saver | BATTERY SAVER | X | X | X |
| Vehicle security system | THEFT ALM | X | X | X |
| RAP (retained accessory power) | RETAINED PWR | X | X | X |
| Signal buffer system | SIGNAL BUFFER | X | X | |
| TPMS (tire pressure monitoring system) | AIR PRESSURE MONITOR | X | X | X |
| Panic alarm system | PANIC ALARM | X | ||
DIAGNOSIS MODE CHART