TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|
| Backing Plate Mounting Bolts | 34-43 (46-58) |
| Booster Mounting Nut | 9-17 (12-23) |
| Brakeline-To-Caliper | 12-14 (16-19) |
| Brakeline-To-Master Cylinder | 10-13 (14-18) |
| Brakeline-To-Wheel Cylinder | 10-13 (14-18) |
| Caliper Guide Pin |
| Dual Piston | 25-32 (34-44) |
| Single Piston | 33-40 (45-54) |
| Caliper Pin Bolt | 23-30 (31-41) |
| Caliper-To-Support Bolt (Rear) | 16-23 (22-31) |
| Hill-Holder |
| PHV Bracket | 22-27 (30-36) |
| PHV Mount | 9-17 (12-23) |
| Hub-To-Rotor Bolt | 33-42 (45-57) |
| Master Cylinder Mounting Nut | 7-13 (10-18) |
| Support Bracket Mounting Bolts |
| Front |
| Dual Piston | 50-65 (68-88) |
| Single Piston | 36-51 (49-69) |
| Rear | 34-43 (46-58) |
| Wheel Bearing Nut |
| Front | 145 (196) |
| Rear | 123-152 (167-206) |
| Wheel Lug Nut | 58-72 (79-98) |
| INCH Lbs. (N.m) |
| Bleeder Screw | 61.2-78.0 (7.0-9.0) |
| Master Cylinder Stop Bolt | 12.0-24.0 (1.4-2.7) |
| PHV Cable Lock Nut | 21.6-39.6 (2.5-4.4) |
DISC BRAKE SPECIFICATIONS
| Application | In. (mm) |
|---|
| Disc Rotor Diameter |
| SVX |
| Front | 11.89 (302.0) |
| Rear | 11.42 (290.0) |
| Lateral Runout (Front Or Rear) | .004 (.10) |
| Parallelism | (1) |
| Original Rotor Thickness |
| Front | 1.10 (28.0) |
| Rear | .39 (10.0) |
| Minimum Refinish Thickness |
| Front | 1.020 (26.00) |
| Rear | .335 (8.50) |
| Discard Thickness | (1) |
| Master Cylinder Diameter |
| Primary & Secondary (With ABS) | 1.060 (26.99) |
| (1) Information is not available from manufacturer. |
| (1) | Information is not available from manufacturer. |
DISC BRAKE SPECIFICATIONS
DRUM BRAKE SPECIFICATIONS
| Application | In. (mm) |
|---|
| Drum Diameter (1) | 7.48 (190.0) |
| Maximum Refinish Diameter (1) | 7.52 (191.0) |
| Discard Diameter | (2) |
| Shoe Width | 1.18 (30.0) |
| (1) Parking brake drum located inside rear disc rotor. (2) Any diameter greater than maximum refinish diameter. |
| (1) | Parking brake drum located inside rear disc rotor. |
| (2) | Any diameter greater than maximum refinish diameter. |
DRUM BRAKE SPECIFICATIONS
