MAINTENANCE OPERATION MODE
| Display | Contents of display | Index No. |
|---|---|---|
| Force Sensor Calibration Mode | Perform the force sensor calibration. | < Refer to FORCE SENSOR CALIBRATION MODE, OPERATION, Subaru Select Monitor. > |
| Break-in Parking Brake Drive Mode | Perform the break-in parking brake drive mode after replacing the parking brake assembly. | < Refer to BREAK-IN PARKING BRAKE DRIVE MODE, OPERATION, Subaru Select Monitor. > |
| Parking Brake Removal Mode | Release the cable tension before removing the parking brake cable. | < Refer to PARKING BRAKE REMOVAL MODE, OPERATION, Subaru Select Monitor. > |
| Parameter Initialization Mode | Perform the parameter initialization. | < Refer to PARAMETER INITIALIZATION MODE, OPERATION, Subaru Select Monitor. > |
| Clutch Sensor Calibration Mode | Perform the clutch sensor calibration. | < Refer to CLUTCH SENSOR CALIBRATION MODE, OPERATION, Subaru Select Monitor. > |
| Clutch Engagement Position Setting | Perform the clutch sensor engagement position setting. | < Refer to CLUTCH ENGAGEMENT POSITION SETTING, OPERATION, Subaru Select Monitor. > |
OPERATION
Note. For detailed operation procedures, refer to "PC application help for Subaru Select Monitor". For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)". < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC). >
Note. For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
Scheme 28
- When warning lights or indicator lights do not illuminate in accordance with this illumination pattern, there must be an electrical malfunction.
- When warning lights or indicator lights remain constantly OFF, check the combination meter circuit or CAN communication circuit. < Refer to «BRAKE WARNING LIGHT»(ref-565207-S07434236022013071000000), ELECTRONIC PARKING BRAKE WARNING LIGHT AND HILL HOLD INDICATOR LIGHT DO NOT COME ON, Warning Light Illumination Pattern. >
- When the electronic parking brake warning light (C6 model only) and hill hold indicator light do not go off, check the combination meter circuit, CAN communication circuit and electronic parking brake control module. < Refer to «ELECTRONIC PARKING BRAKE WARNING LIGHT AND HILL HOLD INDICATOR LIGHT DO NOT GO OFF»(ref-565207-S15506259162013071000000), Warning Light Illumination Pattern. > < Refer to «HILL HOLD INDICATOR LIGHT DO NOT GO OFF»(ref-565207-S17768139332013071000000), Warning Light Illumination Pattern. >
- When the brake warning light does not go off, check the combination meter circuit, CAN communication circuit, electronic parking brake control module, and VDCCM&H/U. < Refer to «BRAKE WARNING LIGHT DOES NOT GO OFF»(ref-565207-S01255108102013071000000), Warning Light Illumination Pattern. > < Refer to «BRAKE WARNING LIGHT REMAINS BLINKING»(ref-565207-S08709648632013071000000), Warning Light Illumination Pattern. >
- After replacing the electronic parking brake control module, the brake warning light blinks. Make sure to perform the Force Sensor Calibration Mode and Clutch Sensor Calibration Mode. < Refer to «FORCE SENSOR CALIBRATION MODE»(ref-565207-S27122390422013071000000), OPERATION, Subaru Select Monitor. > < Refer to «CLUTCH SENSOR CALIBRATION MODE»(ref-565207-S04797925472013071000000), OPERATION, Subaru Select Monitor. >
- When operation and release of the parking brake is repeated excessively, the brake warning light blinks and the parking brake switch operation may not be accepted for several tens of seconds; this is not malfunction, however.
See also:
• BASIC DIAGNOSTIC PROCEDURE
• BASIC DIAGNOSTIC PROCEDURE