Home ReviewsRefund
Home/Subaru/Outback/Subaru Outback BR рестайлинг (2012-2014)/Repair manual/A/t & M/t Differentials/GENERAL TOOL
Contents Section: A/t & M/t Differentials All sections

GENERAL TOOL Subaru Outback BR рестайлинг

A/t & M/t Differentials 3 illustrations ~165 words

GENERAL TOOL

TOOL NAMEREMARKS
Transmission jackUsed for removing and installing the rear differential.
PullerUsed for removing the side bearing retainer.
Thickness gaugeUsed for measuring clearance.
Hexagon wrenchUsed for installing and removing the oil filler plug and oil drain plug.
Tire leverUsed for removing the rear drive shaft. (VA-type)

Scheme 96

Scheme 96: INSPECTION
Scheme 96: INSPECTION

Scheme 97

Scheme 97
Scheme 97

Scheme 98

Scheme 98
Scheme 98
  1. Lift up the vehicle.
  2. Remove the filler plug, and then check the gear oil. Replace the gear oil if it is contaminated, deteriorated or cloudy. Refer to «REPLACEMENT»(ref-565172-S09238729222013071000000) .
  3. Check that the gear oil level is within -5 mm (-0.2 in) from the bottom of the filler plug hole. If the level is low, make sure that there is no oil leakage and refill up to the bottom of filler plug hole. NOTE: On VA1-types at factory settings, the oil level may be within -14 mm (-0.6 in) from the bottom of the filler plug. This is at normal level, requiring no oil refill. T-type VA1-type VA2-type
  4. Install the filler plug. NOTE: For the T-type, apply liquid gasket to the filler plug. Liquid gasket: THREE BOND 1105 (Part No. 004403010) or equivalent For VA type, use a new gasket. Tightening torque: T-type: 49 N.m (5.0 kgf-m, 36.1 ft-lb) VA-type: 50 N.m (5.1 kgf-m, 36.9 ft-lb)