SPECIFICATION
| Fuel tank | Capacity | 64 l (16.9 US gal, 14.1 lmp gal) |
|---|---|---|
| Location | Under rear seat | |
| Fuel pump | Type | Impeller |
| Shutoff discharge pressure | 550 - 850 kPa (5.61 - 8.67 kg/cm 2 , 79.8 - 123.3 psi) | |
| Discharge rate | 155 l (40.9 US gal, 34.1 lmp gal)/h or more. [12 V at 300 kPa (3.06 kg/cm 2 , 43.5 psi)] | |
| Fuel filter | In-tank type | |
GENERAL SPECIFICATION
Scheme 220
Scheme 221
Scheme 222
Scheme 223
Scheme 224
Throttle body is a non-disassembled part, so do not remove the throttle position sensor from throttle body.
Refer to "Throttle Body" for removal and installation procedure. REMOVAL, Throttle Body .> INSTALLATION, Throttle Body .>
Scheme 225
- Disconnect the ground cable from battery.
- Disconnect the connector from the mass air flow and intake air temperature sensor.
- Remove the mass air flow and intake air temperature sensor.
The tumble generator valve assembly cannot be disassembled.
Refer to "Tumble Generator Valve Assembly" for removal and installation procedure. REMOVAL, Tumble Generator Valve Assembly .> INSTALLATION, Tumble Generator Valve Assembly .>
The tumble generator valve assembly cannot be disassembled.
Refer to "Tumble Generator Valve Assembly" for removal and installation procedure. REMOVAL, Tumble Generator Valve Assembly .> INSTALLATION, Tumble Generator Valve Assembly .>
Fuel filter forms a single unit with fuel pump. Refer to "Fuel Pump" for removal and installation. REMOVAL, Fuel Pump .> INSTALLATION, Fuel Pump .>