Wheel Alignment Specifications & Procedures: Adjustments

Wheel Alignment Specifications & Procedures: Adjustments Subaru Impreza GC/GF

RIDING HEIGHT ADJUSTMENT

Before adjusting alignment, check riding height. Riding height must be checked with vehicle on level floor, gas tank full, wheels straight ahead and tires properly inflated. Bounce vehicle several times and allow suspension to settle.
Visually inspect vehicle for signs of abnormal height from front to rear or side to side. Check passenger and luggage compartments for extra heavy items and remove if present. If riding height is not within specifications listed, check, repair or replace suspension components.
Measure front and rear riding height from horizontal center line of wheel axle shaft to bottom line of body/fender wheel opening (directly above vertical center line of axle shaft). Adjust to specifications. See «RIDING HEIGHT SPECIFICATIONS»(ref-54109-S32052192732001100400000) table.

RIDING HEIGHT SPECIFICATIONS

Note. Information is not available at time of publication for Impreza.

Note. Information is not available at time of publication for Impreza.

Application	Preferred	Range
2WD
Camber (1)
Front	0	0.5 To 0.5
Rear	0.83	1.58 To -0.08
Caster (1)	3	2 To 4
Toe-In (2)
Front	0 (0)	0.12 To 0.12 (-3 To 3)
Rear	0 (0)	0.12 To 0.12 (-3 To 3)
Toe-In (1)
Front	0	.24 To .24
Rear	0	.24 To .24
AWD
Camber (1)
Front	0	0.5 To 0.5
Rear	0.92	1.67 To -0.17
Caster (1)	3	2 To 4
Toe-In (2)
Front	0 (0)	0.12 To 0.12 (-3 To 3)
Rear	0 (0)	0.12 To 0.12 (-3 To 3)
Toe-In (1)
Front	0	.24 To .24
Rear	0	.24 To .24
(1) Measurement is in degrees. (2) Measurement is in inches (millimeters).

(1)	Measurement is in degrees.

(2)	Measurement is in inches (millimeters).

WHEEL ALIGNMENT SPECIFICATIONS