Immobilizer (Diagnostics): Overview Subaru Forester SG рестайлинг

OPERATION

1. On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
2. On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On the «Engine Diagnosis» screen, select {DTC Display}, and then press the [YES] key.
5. On the «Diagnostic Code(s) Display» screen, select {Current Diagnostic Code(s)} or {History Diagnostic Code(s)}, and then press the [YES] key. NOTE: For detailed operation procedure. ". For detailed concerning DTC, refer to the List of Diagnostic Trouble Codes (DTC). LIST List of Diagnostic Trouble Code (DTC). >

1. On the «Main Menu» display screen, select (Each System Check} and press the [YES] key.
2. On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On the «Engine Diagnosis» display screen, select the {Clear Memory} and press the [YES] key.
5. When the "Done" is shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF. NOTE: After the memory has been cleared, the idle air control solenoid valve must be initialized. To execute this procedure, turn the ignition switch to ON. Wait 3 seconds before starting the engine. For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL ".