VTD MODEL Subaru Forester SG рестайлинг

VTD MODEL

1. Set the select lever to "P" range.
2. Use a plastic hammer to install reduction driven gear assembly.
3. Use a plastic hammer to install the center differential.
4. Install new self-locking nut and washer. Tightening torque: 100 N.m (10.2 kgf-m, 73.8 ft-lb)
5. After tightening, stake the lock nut securely.
6. Insert the rear driveshaft assembly. INSTALLATION REAR DRIVE SHAFT. >
7. Join the transmission case and the extension case, and then install the rear vehicle speed sensor. INSTALLATION EXTENSION CASE. >
8. Install the transmission assembly to the vehicle. INSTALLATION AUTOMATIC TRANSMISSION ASSEMBLY. >

Scheme 342

1. Remove the snap ring from reduction driven gear.
2. Remove the ball bearing from reduction driven gear using ST. ST 498077600 REMOVER

Scheme 343

Scheme 344

Scheme 345

1. Install the new ball bearing to reduction driven gear using press.
2. Install the snap ring to reduction driven gear.