Draining TIREFIT sealant out of tires - AR40.10-P-1080MCU
Drain Risk of poisoning caused by swallowing the TIREFIT emulsion. Risk of injury caused by skin contact and eye contact with TIREFIT emulsion. Risk of fire caused ignition of the TIREFIT emulsion. Do not swallow or come into contact with TIREFIT tire sealant, which is an emulsion of rubber and terpene phenolic resin. No open fire or open light sources. AS40.10-Z-0001-01A TIREFIT tire sealant AH40.10-P-0001-01MCC 1 Remove wheel AR40.10-P-1100MCU 2 Position the wheel upright with the valve (4) downwards for 10 minutes In order to permit the tire sealant (3) to drain away the wheel must be higher by the dimension (a) than the tire sealant reservoir (1). 3 Unscrew the valve element (4) from the valve and allow the pressure to slowly escape from the tire 4 Unscrew the nut on the valve (4) and press the valve (4) back in the inside of the wheel 5 Attach drain hose (2) to a genuine tire sealant container (1) and insert drain hose (2) through the valve bore of the disk wheel If an empty,, genuine tire sealant container (1) is available. The drain hose (2) should be 400 mm long. 90% of the tire sealant (3) can be removed using this method. 6 Extract tire sealant (3) by compressing and slowly releasing the tire sealant container (1) from the tire If an empty, genuine tire sealant container (1) is available. 7 Use a twist drill bit (dia. approximately 10 mm) to bore through the tire tread and allow the sealant (3) to drain into a suitable container If an empty, genuine tire sealant container (1) is available. Cordless Drill/driver see scheme 29 8 Replace tires Wipe remaining tire sealant (3) off the disk wheel using a damp cloth. AR40.10-P-1030MCU 9 Place new TIREFIT tire sealant container (1) in the vehicle
