GENERATOR SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .374-.453 Inches (9.5-11.5 mm) | ||
| Limit (Minimum) | More Than .177 Inches (4.5 mm) | ||
| Rotor | |||
| Resistance (1) | 2.1-2.5 ohms | ||
| Slip Ring Diameter | |||
| Standard | .559-.567 Inches (14.2-14.4 mm) | ||
| Minimum | .504 Inches (12.8 mm) | ||
| Generator Regulated Output | |||
| Amperage | |||
| Without Load | 10 Or Less Amps | ||
| With Load | 30 Or More Amps | ||
| Voltage | 12.9-14.9 Volts | ||
| (1) Measured @ 68°F (20°C). | |||
| (1) | Measured @ 68°F (20°C). |
GENERATOR SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Generator Mounting Bolt | ||
| 12-mm Bolt | 14 (18) | |
| 14-mm Bolt | 40 (54) | |
| Generator Pulley Nut | 81 (111) | |
| INCH Lbs. (N.m) | ||
| Battery Wire Terminal Nut | 87 (10) | |
| Bearing Retainer Bolt | 27 (3) | |
| Brush Holder Bolt | 18 (2) | |
| Generator Holder With Rectifier | 27 (3) | |
| Generator Rear End Cover | ||
| Nut | 44 (5) | |
| Nut With Cord Clip | 44 (5) | |
| Regulator Assembly | 18 (2) | |
| Serpentine Belt Adjusting Bar | 97 (11) | |
TORQUE SPECIFICATIONS