Home ReviewsRefund Car not listed?
Home/Saturn/ION/Saturn ION I (2003-2007)/Repair manual/Mechanical/Intake Manifold Installation
Contents Wiring diagrams Section: Mechanical All sections

Intake Manifold Installation Saturn ION I

Mechanical ~160 words
  1. Install the intake manifold studs in the manifold face. Tighten: Tighten the intake manifold studs to 5 N.m (44 lb in).
  2. Install a new intake manifold gasket on the intake manifold.
  3. Install the intake manifold.
  4. Install the intake manifold bolts and nuts. Follow the tightening sequence. Tighten: Tighten the bolts and nuts to 10 N.m (89 lb in).
  5. Lubricate the fuel injector tip insulators with engine oil.
  6. Install new fuel injector tip insulators.
  7. Lubricate the fuel injector oil rings with engine oil.
  8. Install the fuel rail assembly.
  9. Install the fuel rail stud. Tighten: Tighten the stud to 10 N.m (89 lb in).
  10. Install a new throttle body gasket.
  11. Install the throttle body and the accelerator control cable bracket. Tighten: Tighten the bolts and nuts to 10 N.m (89 lb in).
  12. Install the EVAP emission canister valve (2). Tighten: Tighten the EVAP canister valve to 22 N.m (16 lb ft).
  13. Install the EVAP emission canister valve tube (1).