Home ReviewsRefund
Home/Saab/9000/Saab 9000 I рестайлинг (1991-1998)/Repair manual/Mechanical/Installation (All Models): Removal & Installation
Contents Section: Mechanical All sections

Installation (All Models): Removal & Installation Saab 9000 I рестайлинг

Mechanical ~141 words

Removal

  1. Remove dipstick. Stuff rag into opening. Raise and support front of vehicle. Drain engine oil. Remove right front wheel and inner fender panel. Remove front and rear engine mount nuts, O2 sensor, and front section of exhaust pipe. Remove torque strut through-bolt. Lift engine slightly. Remove lower oil pan-to-transaxle bolt.
  2. Disconnect wiring from oil level sensor. Remove turbocharger brace and oil return line (if equipped). Fold down splash plate. Remove rubber plugs from transaxle housing to gain access to rear oil pan bolts. Remove oil pan retaining bolts. Tap guide sleeve into engine block. Remove oil pan. Remove guide sleeve.

Clean gasket surfaces. Apply silicone sealant to gasket surfaces. Install rubber seal for oil strainer into groove in oil pan. Reverse removal procedure to complete installation. Tighten bolts to specification. See TORQUE SPECIFICATIONS table.

More articles — Installation (All Models)