Grind intake valves to an angle of 44.5 degrees. DO NOT grind exhaust valve face. Use only lapping compound to finish face.
Contents
Section: Mechanical- Removal & Installation
- Removal & Installation: Overview
- Removal & Installation: Diagnosis
- Removal & Installation: Removal & Installation
- Removal (9000 Series)
- Removal (9000 Series): Overview
- Removal (9000 Series): Diagnosis
- Removal (9000 Series): Removal & Installation
- Removal & Installation (9000 Series): Overview
- Removal & Installation (9000 Series): Removal & Installation
- Installation (All Models)
- Installation (All Models): Overview
- Installation (All Models): Removal & Installation
- Abbreviations
- Accessory Drive Belts
- Adjustments
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic HVAC System
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Computer Relearn
- Cooling Fan
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Driveline/axles
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Identification
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Oem General Information
- Procedures
- Removal & Installation
- Reset Procedures
- Restraints
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Traction Control Disable
- Transmission
- Wheel Alignment
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance