Initializing final deactivation Porsche Cayenne I

initializing final deactivation

Note. After the motor is replaced, the limit stops must be re-initialized.

1. If the limit stops are not initialized, the two LEDs on the switch flash at the same time.

1. Once initialization is completed successfully, the upper LED lights up in the retracted state, while the lower LED is continuously lit in the extended state.

1. Extend the trailer hitch until the limit stop is reached and the motor switches off automatically. Keep the switch pressed when doing this.

2. Retract the trailer hitch until the limit stop is reached and the motor switches off automatically. Keep the switch pressed when doing this.

1. Install trailer hitch. > 669019 Removing and installing trailer hitch - "Installing" section

2. Fit the spare wheel holder on vehicles with an externally fitted spare wheel. Refer to 44 56 19 Removing and installing spare wheel mount (frame) - as of MY 2003 (All Models) .

1. Remove rear roof trim panel. Refer to 70 85 19 Removing and installing rear roof lining - as of MY 2003 (All Models) .

2. Remove C-pillar trim panel. Refer to 70 68 19 Removing and installing C-pillar trim panel - as of MY 2003 (All Models) .

3. Remove D-pillar trim panel. Refer to 70 69 19 Removing and installing D-pillar trim - as of MY 2003 (All Models) .

4. Remove rear side trim panel. Refer to 70 03 19 Removing and installing rear luggage compartment side-trim panel - as of MY 2003 (All Models) .

5. Remove side window. Refer to 64 75 19 Removing and installing side window - as of MY 2003 (All Models) .