Home ReviewsRefund
Home/Porsche/Boxster/Porsche Boxster 987 facelift (2006-2009)/Repair manual/Radio, Telephone, On-Board Computer, Navigation/Installing multi-function control unit
Contents Wiring diagrams Section: Radio, Telephone, On-Board Computer, Navigation All sections

Installing multi-function control unit Porsche Boxster 987 facelift

Radio, Telephone, On-Board Computer, Navigation 2 illustrations ~130 words

Installing multi-function control unit

Note. The control unit is removed and, if necessary, replaced without reading, writing or coding the data with the PIWIS Tester. This procedure is not required at present.

Scheme 107

Scheme 107: Installing multi-function control unit
Scheme 107: Installing multi-function control unit

1. Attach electric plug connection to multi-function control unit until the plug clicks into place.

2. Clip multi-function control unit into steering wheel. Check that it is secure.

Note. When removing the locking plate, take note of how many washers are used on each fastening screw. During installation make sure that the washers are fitted in the same way as they were before removal.

Scheme 108

Scheme 108
Scheme 108

3. Position locking plate on steering wheel and screw down using the four fastening screws -1- and the washers. --> Tightening torque: 4.5 ftlb. (Scheme 105)