Home/Porsche/Boxster S/Porsche Boxster S 987 рестайлинг (2006-2009)/Repair manual/Glazing, Window Control/Preliminary work before windscreen installation

Contents

Section: Glazing, Window Control

Tools

Danger of injury when working on car windows

Material damage when removing the glass from car windows

Removing glass with cutting device - wire separator

Applying protective film to the dashboard

Guiding cutting thread into the passenger compartment

Guiding cutting thread into the gap in the glass

Separating glass as far as P2

Separating glass as far as P3

Separating glass as far as P4

Separating glass as far as P5

Fitting windscreen seal

Warning note on hydrophobic window

Checking front door window

Mixing the components

Cleaning the surface

Reworking (coating) front door window

Pre-treating adhesive flanges on vehicle windows

Pre-treating adhesive flanges on vehicle body

Double cartridge press

Preliminary work

General warning notes

Tools and materials

Removing windscreen

Removing adhesive from the body

Cleaning and priming areas that are free of adhesive residue or have paint damage or where there is newly built-up paint in the window aperture of the body

Removing windscreen seal

Removing adhesive from the windscreen

Marking the bonding area

Activating the bonding section of the windscreen

Priming the windscreen

Preliminary work before windscreen installation

Fitting windscreen into the body

Preparing 2-component adhesive for processing

Applying adhesive to the windscreen

Pulling off protective film

Inserting windscreen into the body

Cleaning fields of vision

Subsequent work

Unclipping electric line for micro switches

Removing microswitch for window opening controls

Installing microswitch for window opening controls

Clipping in the electric line for micro switches

Removing front door window

Installing front door window

Securing front door window

Inserting door trim panel

Standardizing the power windows

Blockage detection function

Precondition for operation of the power windows

Adjusting the door window angle in the vehicle's longitudinal direction

Adjusting the door window height

Adjustment of pressing force of door window edge against seal of convertible top at top and sides

Removing the front window bay seal

Installing the front window shaft seal

Removing front power windows

Adjusting the lower stop of the power window unit

Installing front power windows

Preliminary work for power window motor

Removing power window motor

Installing power window motor

Subsequent work for window power motor

Reading from and writing to the power windows motor (door control unit)

Coding the power windows motor (door control unit)

Removing switch for power windows

Removing side window

Installing side window

Removing rear window (hardtop)

Preparing the window section (hardtop) for installation

Preparing the rear window (hardtop) for installation

Installing rear window (hardtop)

All sections

Preliminary work before windscreen installation Porsche Boxster S 987 рестайлинг

Glazing, Window Control

Preliminary work before windscreen installation

Note. The removed windscreen can be reinstalled if there was no prior damage to the windscreen and the windscreen was removed without damage.

1. Clip in spacer blocks and press in body-bound rivets.

2. Install dashboard cover (defroster trim). Refer to 70 20 19 Removing and installing cover for dashboard (defroster trim) - as of MY 2005 (All Models) .