Installing engine - subsequent work
1. Top up coolant and bleed cooling system. Refer to 19 38 17 DRAINING AND FILLING IN COOLANT - AS OF MY 2005 (CARRERA 2, CARRERA 2S, CABRIO 2, CABRIO 2S, CARRERA 4, CABRIO 4) .
2. Position rear spoiler support with M6 hexagon-head bolt on the body -2-, do not tighten until after fitting the rear spoiler. --> Tightening torque: 7.5 ftlb. (Scheme 153)
3. Install lateral retaining brackets (heat shields) of rear spoiler. Refer to 63 50 19 REMOVING AND INSTALLING REAR BUMPER - AS OF MY 2005 (ALL MODELS) .
4. Install rear spoiler. Refer to 63 55 19 REMOVING AND INSTALLING REAR SPOILER - AS OF MY 2005 (CARRERA 2, CABRIO 2, CARRERA 4, CABRIO 4) .
5. Fit rear wheels, to tighten the wheel bolts use special tool socket wrench insert P 300 . Refer to 44 05 19 Removing and installing wheel - as of MY 2005 (All Models) . --> Tightening torque: 96 ftlb.
6. Connect the battery.
7. Warm up engine to operating temperature and recheck the coolant level. Inspect all cooling system connections that were opened during removal for leaks.
8. Check power steering fluid level (Pentosin) and top up if necessary --> 48 02 01 CHECKING THE FLUID LEVEL FOR THE POWER-ASSISTED STEERING - AS OF MY 2005 (CARRERA 2, CARRERA 2S, CABRIO 2, CABRIO 2S, CARRERA 4, CABRIO 4) .
9. Check engine oil level and top up if necessary --> 17 01 01 CHECKING ENGINE OIL LEVEL - AS OF MY 2005 (CARRERA 2, CARRERA 2S, CABRIO 2, CABRIO 2S, CARRERA 4, CABRIO 4) .
10. Remove protective covers.
Designation Type Number Explanation spark plug socket wrench commercially available tool 14 cover for dust protection when fitting the engine special tool NR.165 release key special tool P 9204 relay puller special tool P 9235 Engine support special tool P 9589 mounting elements special tool P 9590 retaining device special tool P 9593 socket wrench insert special tool P 9594 retaining tool special tool P 9685 adjusting gauge special tool P 9686 holding wrench special tool P 9732
