SPECIFICATIONS
| Application | Specification |
|---|
| Compressor Type | Harrison V5 5-Cyl. |
| Compressor Belt Tension | (1) |
| System Oil Capacity | (2) 9.0 ozs. |
| Refrigerant (R-134a) Capacity | 35 ozs. |
| System Operating Pressures (3) |
| High Side | 180-210 psi (12.6-14.7 kg/cm 2 ) |
| Low Side | 37-43 psi (2.6-3.0 kg/cm 2 ) |
| (1) Tension is adjusted automatically. Belt tension is okay if indicator mark on belt tensioner is within marked limits. (2) Use PAG Refrigerant Oil (Part No. 12356151). (3) Approximate operating pressures at 80°F (27°C) and humidity at 40 percent or more. |
| (1) | Tension is adjusted automatically. Belt tension is okay if indicator mark on belt tensioner is within marked limits. |
| (2) | Use PAG Refrigerant Oil (Part No. 12356151). |
| (3) | Approximate operating pressures at 80°F (27°C) and humidity at 40 percent or more. |
TORQUE SPECIFICATIONS
| Application | Specification |
|---|
| Compressor Hose Assembly-To-Compressor Nut | 31 (39) |
| Compressor Hose-To-Accumulator Nut | 15 (20) |
| Compressor Hose-To-Condenser Nut | 15 (20) |
| Compressor Mounting Nuts (Front) | 37 (50) |
| Compressor Mounting Bolt (Rear) | 37 (50) |
| Compressor Mounting Bracket Rear Bolt | 37 (50) |
| Compressor Mounting Bracket Side Bolts | 74 (100) |
| Evaporator Hose Assembly-To-AccumulatorNut | 15 (20) |
| Evaporator Hose Assembly-To-Condenser Nut | 15 (20) |
| Evaporator Hose Assembly-To-Evaporator Nut | 15 (20) |
| Expansion Tube O-Ring Fitting | 20 (27) |
| INCH Lbs. |
| A/C Refrigerant Pressure Sensor | 44 (5) |
| Air Distribution Duct Screws | 12 (1.4) |
| Blower Control Module Screws | 18 (2) |
| Blower Motor Screws | 12 (1.4) |
| Condenser-To-Radiator Mounting Bolts | 53 (6) |
| Defroster Duct-To-Front Of Dash Nut | 80 (9) |
| Defroster Duct-To-Module Screws | 12 (1.4) |
| Evaporator Core Cover | 12 (1.4) |
| Front Fascia-To-Tie Bar Support Brackets | 80 (9) |
| Headlamp/Bumper Fascia Mounting Panel Fasteners | 80 (9) |
| Heater Core Cover | 12 (1.4) |
| Heater Core Retaining Screw | 12 (1.4) |
| Heater Pipe Adapter Bolt | 89 (10) |
| HVAC Module Mounting Nuts | 80 (9) |
| Mode Actuator Screws | 12 (1.4) |
| Positive Battery Cable-To-Underhood Fuse Block Nut | 132 (15) |
| Recirculation Actuator Screws | 12 (1.4) |
| Service Port | 106 (12) |
| Temperature Actuator Screws | 12 (1.4) |
| Upper Radiator Mounting Brackets | 80 (9) |
| Wiring Harness Bracket | 106 (12) |
Automatic A/C-Heater System Wiring Diagram (2002 Bonneville - 1 Of 2). Scheme 1
Scheme 1: Automatic A/C-Heater System Wiring Diagram (2002 Bonneville - 1 Of 2)
Automatic A/C-Heater System Wiring Diagram (2002 Bonneville - 2 Of 2). Scheme 2
Scheme 2: Automatic A/C-Heater System Wiring Diagram (2002 Bonneville - 2 Of 2)
