DESCRIPTION & OPERATION
Power windows are operated by a permanent magnet type electric motor mounted in each door. Driver's power window switch provides ground to each motor. A 30-amp circuit breaker, located behind fuse block, is used to protect power window circuit. Changing polarity at each motor will cause motor to rotate in reverse direction.
Up-Stop Adjustment
- Remove door panel, if not already removed. See «DOOR TRIM PANEL»(ref-123840-S03639269692001092700000) under REMOVAL & INSTALLATION. Loosen up-stop nut. (Схема №1)or (Схема №2). Close door and raise window. Adjust up-stop until window is at proper height.
- Top edge of window should be beneath lip of weatherstrip. To check adjustment, slide a piece of paper between window and weatherstrip. Some tension should be felt. Tighten up-stop nut. Install door trim panel.