Manual sections
Wiring diagrams- Battery
- Body
- Bodywork
- Braking
- Comfort and convenience
- Confort
- Connector pinouts
- Current generation
- Dashboard
- Driver information
- Driving assistance
- Electrical harnesses
- Engine
- Front anti -roll bar
- Front axle
- Front doors
- Front seats
- Front section
- Front shock absorbers
- Gearbox assembly
- General points
- General points about the vehicle
- Instrument panel
- Instruments and controls
- Lighting - signalling
- Mechanical
- Noises and vibrations
- Other
- Power unit
- Pre-heating
- Protections and doors
- Rear axle
- Rear door windows
- Rear doors
- Rear parcel tray
- Rear seats
- Rear section
- Rear shock absorbers
- Roof panel
- Side structure
- Starting
- Steering
- Suspension
- Towbar
- Transmission
- Washing and wiping
Repair manual
Battery Peugeot 508 I
Step-by-step instructions on "Battery" for Peugeot 508 I (2011–2014). Pick an article — removal, installation, adjustment and diagnostics with illustrations.
Articles in this section
- Preliminary check: before fitting the ancillaries battery on the vehicle (except traction battery)
- Operations to be performed: before disconnection and after reconnection of the ancillaries battery
- New vehicle preparation: Checking the ancillaries (service) battery
- Removing - refitting: ancillaries battery charge status control unit
- Dismantling - re-assembly: high voltage cable (hybrid control ECU - reversible alternator) (DW10CTED4)
- Removing - refitting: ancillaries battery charge status control unit — variant 2
- Discharge: energy accumulator (ultra capacity) (DV6C, 2.0 HDi 150 FAP)
- Operating methods: battery charge status control unit
- Table: fault codes - battery charge status unit (Summary)
- Help in diagnosis: economy mode
- Help in diagnosis: lighting of the battery charge warning lamp (DW10CTED4, EP6C, DV6C, DW12C, DW10BTED4)
- Help in diagnosis: battery discharged
- Operations to be performed: before and after a disconnection of the ancillaries battery (technical note)