Note. Fastening bolts which are fitted using the torque and angle method (beyond the elastic limit) must not be re-used in Service after they have been released,
| Nm | |
|---|---|
| Airbag unit to steering wheel | 8 |
| Pressure line to electro-hydraulic supply unit (Delphi) | 27.5 |
| Pressure line to electro-hydraulic supply unit (TRW) | 30 |
| Pressure line to steering gear (Delphi) | 27.5 |
| Pressure line to steering gear (TRW) | 30 |
| Damping bush to bracket and electro-hydraulic supply unit (TRW) | 7 |
| Pressure and return line bracket to steering gear | 4 |
| Electro-hydraulic supply unit bracket to steering gear | 22 |
| Electro-hydraulic supply unit bracket to front axle body | 22 |
| Engine damping block bracket to rear of transmission | 80 |
| Engine damping block bracket to rear of engine damping block | 55 |
| Shift guide bracket to front axle body | 20 |
| Heat shield to steering gear | 4 |
| Heat shield for steering gear lines to front axle body | 6 |
| Clamp bolt for steering column assembly | 22 |
| Tie rod to tie rod end lock nut | 60 |
| Steering gear to front axle body | 45 + 45° + 15° 1) |
| Steering gear lines to steering gear | 30 |
| Steering wheel to steering shaft | 20 |
| Steering column assembly to crossmember | 22 |
| Return line to steering gear (Delphi) | 27.5 |
| Return line to steering gear (TRW) | 30 |
| Tie rod to steering gear rack | 90 2) |
| Tie rod end to steering knuckle | 50 3) |
| Intermediate shaft to steering gear shaft | 22 4) |
| Intermediate shaft to steering shaft | 22 4) |
1
) Use new fixing bolts and nuts
2
) Clean rack thread and coat with locking compound
3
) Use new fastening nut
4
) Clean thread and insert clamp screw with locking compound