Flywheel
| Starter ring gear | Heat ring gear to 200°C before fitting | |
|---|---|---|
| Friction surface depth 'A' | mm | 18-19 |
| Surface roughness | mm | Less than 0.006 |
Home/Opel/Monterey/Opel Monterey A (1992-1999)/Repair manual/Diesel Engine/Technical Data - Flywheel - 4JG2T
Contents
Section: Diesel Engine- Introduction
- General Instructions, Safety Instructions DOHC Turbodiesel Engine 4JX1
- Alteration to Fastening Bolt for Crankshaft Pulley
- How to Check the Compression (4JX1)
- Amendment of the Service Instructions -
- How to Check the Loss of Compression (4JX1)
- How to Measure the Fuel Consumption (4JX1)
- Drive Belts: Check, Retension
- Diesel Engine Timing Belt Tooth Profile All Rv/lcv with Isuzu 4J Diesel Engines
- How to Check the Idle Speed (4JX1)
- How to Check and Adjust the Valve Play (4JX1)
- Diesel Fuel Filter: Drain Water
- How to Check the Timing (4JX1)
- How to Remove and Install 4JX1 the Toothed Belt Covers
- How to Remove and Install the Toothed Belt
- How to Remove and Install the Toothed Belt Tensioner (4JX1)
- How to Replace the Seal Between Exhaust Manifold and Cylinder Head (4JX1)
- How to Replace the Seal Between Intake Manifold and Cylinder Head (4JX1)
- How to Remove and Install the Valve Springs (4JX1)
- How to Replace the Valve Stem Seal Ring (4JX1)
- How to Remove and Install the Cylinder Head (4JX1)
- Cylinder Head, Disassemble and Assemble (4JX1)
- How to Overhaul the Cylinder Head (4JX1)
- How to Check for Plane Surface the Cylinder Head (4JX1)
- How to Check the Valve Gap (4JX1)
- How to Replace the Valve Guide (4JX1)
- How to Remove and Install the Camshaft Cladding (4JX1)
- How to Replace the Camshaft Housing Cover Seal (4JX1)
- How to Remove and Install the Camshafts and Valve Lifters (4JX1)
- Camshaft and Valve Lifters Check - 4JX1
- Intake Tract, 4JG2T Engine
- How to Replace the Camshaft Bearing (4JX1)
- How to Replace the Camshaft Housing Seal at Cylinder Head (4JX1)
- How to Remove and Install the Flywheel (4JX1)
- How to Remove and Install the Crankcase Housing (4JX1)
- How to Remove and Install 4JX1 the Piston with Con-Rod
- How to Remove and Install the Piston Rings
- How to Replace the Con-Rod Bearing (4JX1)
- How to Replace the Con-Rod or Piston
- How to Remove and Install the Con-Rod Bushing (4JX1)
- Motor Add-On Components, Turbo Diesel 4JX1 General
- How to Remove and Install the Crankshaft (4JX1)
- Turbo Diesel 4JX1: Motor Data, -Number, Intake Air Conduction
- Crankshaft Check - 4JX1
- Motor Add-On Components, Turbo Diesel 4JX1 Cylinder Head and Valves
- How to Replace the Crankshaft Oil Seal Ring Front (4JX1)
- Motor Add-On Components, Turbo Diesel 4JX1 Camshaft, Housing and Tappet
- How to Replace the Crankshaft Oil Seal Ring Rear (4JX1)
- Motor Add-On Components, Turbo Diesel 4JX1 Motor Control, Gearbox
- How to Remove and Install the Upper Balancer Shaft (Cylinder Block) (4JX1)
- Motor Add-On Components, Turbo Diesel 4JX1 Control Belts and Pulleys
- How to Remove and Install the Lower Balancer Shaft (Crankcase Housing) (4JX1)
- Motor Add-On Components, Turbo Diesel 4JX1 Alignment and Setting, Camshafts
- Drive Belts
- How to Remove and Install the Vacuum Pump (4JX1)
- Motor Add-On Components, Turbo Diesel 4JX1 Motor Unit and Crankcase
- How to Replace the Primary Oil Filter Insert (4JX1)
- Motor Add-On Components, Turbo Diesel 4JX1 Crank Mechanism, Flywheel
- How to Replace 4JX1 the Secondary Oil Filter Insert
- Motor Add-On Components, Turbo Diesel 4JX1 Oil Circulation: Diagram
- How to Remove and Install 4JX1 the Primary Oil Pump
- Motor Add-On Components, Turbo Diesel 4JX1 Oil Circulation: Oil Sump, Oil Pumps
- How to Remove and Install 4JX1 the Secondary Oil Pump
- Turbo Diesel 4JX1: Oil Circulation; Oil Cooling System, Oil Pressure Display
- How to Remove and Install the Oil Cooler (4JX1)
- Motor Add-On Components, Turbo Diesel 4JX1 Vacuum Pump
- How to Remove and Install 4JX1 the Oil Distributor Pipe
- How to Remove and Install the Oil Pan
- Turbo Diesel 4JX1, Motor Damping Units Auxiliary Unit-Drive Belt
- Diesel Engine Oil Change
- How to Remove and Install the Engine Mounting Blocks (4JX1)
- How to Remove and Install the Engine (4JX1)
- How to Check for Plane Surface the Cylinder Block (4JX1)
- Oil Pan Bolts Loosen
- Special Service Tools - 4JX1
- Technical Data Engine Oil Viscosity - 4JX1
- Technical Data Engine Oil Quality - 4JX1
- Technical Data Disposal - 4JX1
- Tightening Torques - 4JX1
- Illustrations Ohv Diesel Engine 4JG2T with Intercooler
- General Instructions, Safety Instructions (4JG2T Engine)
- How to Check the Compression (4JG2T)
- How to Check (4JG2T) the Loss of Compression
- How to Measure the Fuel Consumption (4JG2T)
- How to Check and Adjust 4JG2T the Idle Speed
- How to Check the Toothed Belt (4JG2T)
- How to Adjust 4JG2T the Valve Play, Check And
- How to Check the Timing (4JG2T)
- How to Remove and Install 4JG2T the Toothed Belt Covers
- How to Remove and Install the Toothed Belt (4JG2T)
- How to Replace the Seal Between Exhaust Manifold and Cylinder Head (4JG2T)
- How to Replace the Seal Between Intake Manifold and Cylinder Head (4JG2T)
- How to Replace 4JG2T the Seal, Cylinder Head Cover
- How to Remove and Install the Rocker Arm (4JG2T)
- How to Remove and Install the Rocker Arm Axle and Rocker Arm (4JG2T)
- How to Remove and Install the Valve Springs (4JG2T)
- How to Replace the Valve Stem Seal Ring (4JG2T)
- How to Remove and Install the Cylinder Head (4JG2T)
- Cylinder Head, Disassemble and Assemble 4JG2T
- How to Replace the Cylinder Head (4JG2T)
- Valve, Grind In (4JG2T)
- How to Replace the Valve Guide (4JG2T)
- How to Replace the Valve Seat (4JG2T)
- Valve Seat, Cut (4JG2T)
- How to Replace the Swirl Chamber, Check And (4JG2T)
- How to Check for Plane Surface the Cylinder Head (4JG2T)
- How to Check 4JG2T the Valve Gap
- How to Remove and Install the Camshaft and Valve Lifters (4JG2T)
- How to Check 4JG2T the Camshaft and Valve Lifters
- How to Replace the Camshaft Bearing (4JG2T)
- How to Remove and Install the Flywheel (4JG2T)
- How to Replace the Starter Ring Gear (4JG2T)
- How to Remove and Install the Oil Pan (4JG2T)
- How to Remove and Install the Piston with Con-Rod (4JG2T)
- How to Remove and Install the Piston Rings (4JG2T)
- How to Replace the Con-Rod Bearing (4JG2T)
- How to Replace 4JG2T the Con-Rod or Piston
- How to Remove and Install the Con-Rod Bushing (4JG2T)
- How to Remove and Install the Crankshaft (4JG2T)
- How to Check the Crankshaft (4JG2T)
- How to Replace 4JG2T the Crankshaft Seal Ring Front
- How to Replace 4JG2T the Crankshaft Seal Ring Rear
- How to Remove and Install 4JG2T the Oil Filter Insert
- How to Remove and Install the Oil Pump (4JG2T)
- How to Overhaul the Oil Pump (4JG2T)
- How to Remove and Install the Oil Cooler (4JG2T)
- How to Remove and Install the Water Pump Drive Belts (4JG2T)
- How to Remove and Install 4JG2T the Engine Mounting Blocks
- How to Remove and Install 4JG2T the Engine Without Transmission
- How to Repair Using Short Block 4JG2T the Engine
- How to Check the Cylinder Sleeve (4JG2T)
- How to Replace the Cylinder Sleeve (4JG2T)
- How to Check the Engine Block, Check for Plane Surface (4JG2T)
- How to Remove and Install 4JG2T the Vacuum Pump
- Vacuum Pump, Disassemble and Assemble (4JG2T)
- How to Check the Vacuum Pump (4JG2T)
- Special Service Tools - 4JG2T
- Technical Data - Oil Circuit - 4JG2T
- Technical Data - Disposal of Engine Oil - 4JG2T
- Technical Data - Engine Oil Filling Volume - 4JG2T
- Technical Data - Oil Pump - 4JG2T
- Technical Data - Adjustment/checking Values - 4JG2T
- Technical Data - Cylinder Head Seal - 4JG2T
- Technical Data - Cylinder Head Dimensions - 4JG2T
- Technical Data - Valve Seat Width and Valve Seat Reworking - 4JG2T
- Technical Data - Valve Dimensions - 4JG2T
- Technical Data - Valve Springs - 4JG2T
- Technical Data - Rocker Arm Axle and Rocker Arm - 4JG2T
- Technical Data - Camshaft - 4JG2T
- Technical Data - Valve Lifters - 4JG2T
- Technical Data - Cylinder Sleeve - 4JG2T
- Technical Data - Piston - 4JG2T
- Technical Data - Piston Rings - 4JG2T
- Technical Data - Piston Pin - 4JG2T
- Technical Data - Table of Main Bearing Shells - 4JG2T
- Technical Data - Crankshaft - 4JG2T
- Technical Data - Flywheel - 4JG2T
- Technical Data - Cylinder Block - 4JG2T
- Tightening Torques - 4JG2T
- ABS
- ABS 5.3
- Accessories
- Air Conditioning
- Airbag
- Antenna
- Anti-Theft Warning System-M
- Automatic Transmission Rear Wheel Drive
- Battery
- Body Equipment
- Brake Hydraulics, Brake Lines
- Brakes
- Central Door Locking System
- Central Locking with Atws (Electronic)
- Clutch
- Clutch and Transmission
- Cooling System
- Diesel Engine
- Distributor Transmission Four Wheel Drive
- DOHC Petrol Engine
- Electrical Equipment and Instruments
- Electrical Window Winders
- Electronic Cruise Control
- Engine and Engine Aggregates
- Engine Electrics
- Exhaust System
- Fittings, Hinges, Locks
- Frame
- Front End
- Front Wheel Brake
- Front Wheel Suspension
- Front Wheel Suspension, Wheels and Tyres
- Fuel and Exhaust System
- Fuel Injection Systems
- Fuel System
- Fuse Box
- General Vehicle Information
- Glass, Window Guides, Window Winders
- Headlamps, Lamps and Horn
- Heating, Ventilation
- Heating, Ventilation, Air Conditioning (HVAC)
- Immobiliser
- Instruments, Telltales
- Maintenance, Body and Chassis Sheet Metal Parts, Frame
- Manual Transmission Four Wheel Drive
- Manual Transmission Rear Wheel Drive
- OHC Petrol Engine
- Outside Rear View Mirror
- Paint
- Painting Repair Operations
- Painting Repair System
- Power Steering
- Radiator Grille
- Radio
- Rear Axle and Rear Wheel Suspension
- Rear Axle Rear Wheel Drive
- Rear Wheel Brake
- Seat Heating Systems
- Seats, Upholstery, Inner Trim Panels
- Secondary Air Injection
- Service Brake, Parking Brake
- Sheet Metal Parts (Bolted)
- Sheet Metal Parts (Cement and Seal)
- Sheet Metal Parts (Welded)
- Sliding Roof
- Steering
- Steering Gear
- Steering Linkage
- Steering Wheel - Steering Column
- Switches, Control Unit, Relays, Ignition Lock
- Trim Panels, Radiator Grille, Spoiler
- Trim Strips, Lettering, Coverings
- Turbo-Charging
- Wheels and Tyres
- Windscreen Wash/wipe System, Heated Screen
- Wiring Harnesses