DTC b1008
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1008 00:
Calibration Data Not Programmed
Circuit/system Description
When replacing a remote control door lock receiver (RCDLR), the service replacement part is shipped with no installed software. Before the new RCDLR is operational, a software calibration is required to be downloaded using the SPS terminal. Failure to download this software calibration will result in the setting of DTC B1008.
Conditions for Running the DTC
This DTC runs continuously
Conditions for Setting the DTC
The RCDLR has no calibration loaded.
Action Taken When the DTC Sets
All functions handled by the RCDLR are inoperative
Conditions for Clearing the DTC
A current DTC will clear when software calibrations are installed.
Reference Information
Schematic Reference
Remote Function Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Keyless Entry System Description and Operation
Electrical Information Reference (Except Opel Gt)
| • | Circuit Testing |
| • | Connector Repairs |
| • | Testing for Intermittent Conditions and Poor Connections |
| • | Wiring Repairs |
Scan Tool Reference
Control Module References for scan tool information
Circuit/system Verification
- Perform the RCDLR Programming and Setup procedure. Refer to Remote Control Door Lock Receiver Programming and Setup .
- Operate the vehicle within the Condition for Running the DTC and verify the DTC does not reset.
Repair Instructions
Important: This vehicle may be equipped with the 2 Way Advanced Remote Start System. Vehicle equipped with the 2 Way Advanced Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label on the RCDLR. When servicing the 2 Way Advanced Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the 2 Way Advanced Remote Start System can be found in the Accessory section of the parts manual.
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for RCDLR replacement, setup, and programming