Home/Opel/GT/Opel GT II (2007-2009)/Repair manual/Programming and Setup/Engine Control Module Programming and Setup

Contents

Section: Programming and Setup

All sections

Engine Control Module Programming and Setup Opel GT II

Programming and Setup

Engine Control Module Programming and Setup

The following service procedures require either a programming or a setup event be performed for a complete repair.

ECM Replacement

If the engine control module (ECM) is replaced, the ECM Reprogramming procedure must be performed. Refer to Service Programming System (SPS) .
Clutch Pedal Position Sensor Learn--Refer to Clutch Pedal Position Sensor Learn .

ECM Reprogramming

If the ECM needs to be reprogrammed, refer to Service Programming System (SPS) .