| Nm | |
|---|---|
| EPS steering column to steering crossmember | 22 1) |
| Tie rod end lock nut to tie rod | 50 |
| Steering gear to front axle body | 45 + 45° 2) |
| Steering wheel to steering shaft | 30 3) |
| Steering column assembly to steering crossmember | 22 1) |
| Steering intermediate shaft to steering pinion (steering gear) lower clamp bolt | 55 4) |
| Steering intermediate shaft to steering pinion (steering gear) upper clamp bolt | 40 |
| Steering intermediate shaft to steering shaft (steering column) clamp bolt | 24 + 60° 5) |
| Wheel Bolts | 110 |
| Tie rod (axial joint) to steering gear rack | 70 6) |
| Tie rod joint end to steering knuckle | 35 |
1
) Observe tightening sequence
2
) Use new fastening bolts, new washers and new self-locking nuts
3
) Re-cut thread in steering shaft and insert bolt with locking compound
4
) Use new self-locking nut
5
) Re-cut thread and insert clamp bolt with locking compound
6
) Re-cut thread in axial joint, clean thread on tie rod and attach axial joint with locking compound