Ignition Switch Replace Opel Antara I



Ignition Switch Replace

Remove

1. Disconnect the negative battery cable.
2. Remove the driver knee bolster. Refer to Driver Knee Bolster Replace .
3. Set the ignition key to ON position.
4. Disconnect the electrical connector.
5. Remove the ignition switch retaining screws.

Install

1. Install the ignition switch retaining screws.

Tighten

Tighten the ignition switch retaining screws to 2.5 N•m (22 lb-in).

2. Connect the electrical connector.
3. Install the driver knee bolster. Refer to Driver Knee Bolster Replace .
4. Connect the negative battery cable.