Side Airbag Sensor Replace Opel Antara I



Side Airbag Sensor Replace

Remove

Warning: The sensing and diagnostic module(SDM) can maintain sufficient voltage to deploy the airbags and pretensioners for 1minute after the ignition is OFF and the fuse has been removed. If the airbags and pretensioners are not disconnected, do not begin service until one minute has passed after disconnecting power to SDM. If the airbags are disconnected, service can be executed immediately without waiting for one-minute time period to expire. Failure to temporarily disable the SIR during service can result in unexpected deployment, personal injury and unnecessary SIR repairs.

1. Disconnect the negative battery cable.
2. Remove the centre pillar lower garnish moulding. Refer to Centre Pillar Lower Garnish Moulding Replace .
3. Disconnect the electrical connector.
4. Remove the side airbag sensor mounting bolt.
5. Remove the side airbag sensor.

Install

1. Install the side airbag sensor.
2. Install the side airbag sensor mounting bolt.

Tighten

Tighten the side airbag sensor mounting bolt to 10 N•m (7 lb-ft).

3. Connect the electrical connector.
4. Install the centre pillar lower garnish moulding. Refer to Centre Pillar Lower Garnish Moulding Replace .
5. Connect the negative battery cable.