| EGE check list, test and adjustment instructions for petrol engines from MY 2005 | |||
|---|---|---|---|
| Work item no. | Questions to the customer: | ||
| A | Last service check / inspection of timing belt | [months / km] | |
| C | Engine oil consumption | [l / 100 km] | |
| Work item no. | Visual check Completeness, absence of leaks, damage, laying, thermal loading, see TIS | ||
| 1.1 | Exhaust and muffler system | ||
| 1.2 | Catalyst | ||
| 1.3 | Oxygen sensors | ||
| 1.4 | Rubber mounts | ||
| 3.1 + | Air cleaner | ||
| 3.2 + | Fuel filter | ||
| 5 | Exhaust gas recirculation | ||
| 6 | Tank restriction (fuel tank filler neck), fuel filler flap | ||
| 8 | Fuel system | ||
| 9 | Engine oil | ||
| 10 | Vacuum hoses, hose connections | ||
| 11 | Seals | ||
| Work item no. | Function check, see adjustment data | ||
| 12.1 | MIL lamp: Ignition ON, Engine OFF = Lamp ON | ||
| 12.2 | MIL lamp: Engine ON = Lamp OFF | ||
| 13 | SVS lamp (engine / transmission function) | ||
| 13.1 | Readiness code test 1) | ||
| 14 | Connect EGE test device | ||
| 15 | Engine operating temperature (nominal: >= 60 °C) | ||
| 16.1 + | Idle speed | ||
| 17.2 | CO content, > 3000 rpm, behind catalyst: <= 0.2% by volume | ||
| + if EGE test failed, additional checks are possible (agree follow-up work with customer) | |||
1
) If the vehicle has not run through all drive cycles supported, so not all readiness codes are set, the special setting test in the Emissions Test must be performed.