Home ReviewsRefund
Home/Oldsmobile/Cutlass/Oldsmobile Cutlass VI (1997-1999)/Repair manual/Body, Cab Control Systems/DTC U2002, TRANSMITTED SPI DATA INPUT LOW
Contents Wiring diagrams Section: Body, Cab Control Systems All sections

DTC U2002, TRANSMITTED SPI DATA INPUT LOW Oldsmobile Cutlass VI

Body, Cab Control Systems ~367 words

Note. DTCs U2006 and U2007 must be diagnosed before DTC U2002.

  1. If BFC diagnostic system check was performed, go to next step. If BFC diagnostic system check was not performed, go to «BFC DIAGNOSTIC SYSTEM CHECK»(ref-32837-S31507406202001101500000) .
  2. Disconnect instrument cluster. See «INSTRUMENT PANEL»(ref-32951) article. Turn ignition on. Using scan tool, establish communications with BFC. Using DVOM, check voltage by backprobing between instrument cluster harness connector terminal A2 (Light Blue/Black wire) and ground. If battery voltage exists, go to next step. If battery voltage does not exist, go to step 7).
  3. Using scan tool, check SPI data input. If SPI data input is HIGH, go to next step. If SPI data input is not HIGH, go to step 11).
  4. Check for a poor connection at instrument cluster harness connector terminal A2 (Light Blue/Black wire). If a poor connection exists, go to next step. If connection is okay, go to step 6).
  5. Repair poor connection at instrument cluster harness connector terminal A2 (Light Blue/Black wire). Go to step 14).
  6. Replace instrument cluster. See «INSTRUMENT PANEL»(ref-32951) article. Go to step 14).
  7. Disconnect BFC 24-pin Gray connector C2. Using DVOM, check resistance between BFC harness connector C2, terminal B7 (Light Blue/Black wire) and instrument cluster harness connector terminal A2 (Light Blue/Black wire). If resistance is 0-2 ohms, go to next step. If resistance is not 0-2 ohms, go to step 9).
  8. Check resistance between BFC harness connector C2, terminal B7 (Light Blue/Black wire) and ground. If resistance is not infinite, go to step 11). If resistance is infinite, go to step 10).
  9. Repair open in Light Blue/Black wire between BFC connector C2 and instrument cluster. Go to step 14).
  10. Repair short to ground in Light Blue/Black wire between BFC connector C2 and instrument cluster. Go to step 14).
  11. Check for a poor connection at BFC connector C2, terminal B7 (Light Blue/Black wire). If a poor connection exists, go to next step. If connection is okay, go to step 13).
  12. Repair poor connection at BFC connector C2, terminal B7 (Light Blue/Black wire). Go to step 14).
  13. Replace BFC. See «REMOVAL & INSTALLATION»(ref-32837-S37603108962001101500000) . Go to next step.
  14. Clear DTCs. Perform «BFC DIAGNOSTIC SYSTEM CHECK»(ref-32837-S31507406202001101500000) .

More articles — Body Control Module