Parts Requiring Angular Tightening
- Use an angle wrench for the final tightening of the following engine parts. Cylinder head bolts Lower cylinder block bolts Connecting rod cap bolts Crankshaft pulley bolt (No angle wrench is required as the bolt flange is provided with notches for angular tightening)
- Do not use a torque value for final tightening.
- The torque value for these parts are for a preliminary step.
- Ensure thread and seat surfaces are clean and coated with engine oil.
General Specifications
| Engine | QG18DE | |
|---|---|---|
| Classification | Gasoline | |
| Cylinder arrangement | 4, in-line | |
| Displacement cm 3 (cu in) | 1,769 (107.94) | |
| Bore x stroke mm (in) | 80.0 x 88.0 (3.150 x 3.465) | |
| Valve arrangement | DOHC | |
| Firing order | 1--3--4-2 | |
| Number of piston rings | Compression | 2 |
| Oil | 1 | |
| Number of main bearings | 5 | |
| Compression ratio | 9.5 | |
Engine General Service Data And Specifications (SDS)
Scheme 251
Scheme 252
Scheme 253
Scheme 254
Scheme 255
Scheme 256
Scheme 257
Whenever valve clearances are adjusted to cold specifications, check that the clearances satisfy hot specifications and adjust again if necessary.
Scheme 258
Scheme 259
Scheme 260
Scheme 261
Scheme 262
Scheme 263
Scheme 264
Scheme 265
Scheme 266
Scheme 267
Scheme 268
Scheme 269
Scheme 270
Scheme 271
Scheme 272
Scheme 273
Scheme 274
Scheme 275
Scheme 276
See also:
• THROTTLE VALVE CLOSED POSITION LEARNING