Contents Wiring diagrams Section: Hoist/jack All sections

General Information: Application Nissan Sentra B15

Function and System Application

Diagnostic test modeFunctionENGINEA/TABSAIR BAGSMART ENTRANCENVIS (NATS) (1)
Work supportThis mode enables a technician to adjust some devices faster and more accurate by following the indications on CONSULT-II.XX
Self-diagnostic resultsSelf-diagnostic results can be read and erased quickly.XXXXX
Trouble diagnostic recordCurrent self-diagnostic results and all trouble diagnostic records previously stored can be read.X
ECU discriminated No.Classification number of a replacement ECU can be read to prevent an incorrect ECU from being installed.X
Data monitorInput/Output data in the ECU (ECM) can be read.XXX
DTC work supportThis mode enables a technician to set operating conditions to confirm self-diagnosis status/results.X
Data monitor (Spec.)The specified values will be displayed when an OK/NG judgement is difficult for the DATA MONITOR items by Bar Chart and Line Graph.X
Active testDiagnostic Test Mode in which CONSULT-II drives some actuators apart from the ECU (ECM) and also shifts some parameters in a specified range.XX
ECU (ECM) part numberECU (ECM) part number can be read.XXX
Control unit initializationAll registered ignition key IDs in NATS components can be initialized and new IDs can be registered.X
Function testConducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG".XX
SRT & DTC confirmationThe results of SRT (System Readiness Test) and the self-diagnosis status/results can be confirmed.X
REMO CONT ID SET UPA maximum of four IDs (identifications) can be registered in the memory using the remote controller. These IDs can also be confirmed and erased.X
X: Applicable
(1) NVIS (NATS) [Nissan Vehicle Immobilizer System (Nissan Anti-Theft System)]
(1)NVIS (NATS) [Nissan Vehicle Immobilizer System (Nissan Anti-Theft System)]

FUNCTION AND SYSTEM APPLICATION